Just noticed that there are a couple tips I picked up in my career that I never see on the topic of injections. One is to dart the needle in quickly and smoothly. I've seen many videos of people pushing the needle in slowly. In my experience, patients report much less pain when it is done very fast and smooth. I have never water bathed a substance but with more viscos injections such as tetanus it helps a lot to roll the vial between your hands quickly for a couple minutes to warm it up before wiping the top with an alcho swab. I also instruct them to relax the muscle to be injected as much as they can. I usually get very got reports with these methods (on my patients). Hope it helps someone.
50cc of water in the unsealed vial, and mark where that line was with a marker, and set both vials side by side and mark on the sterile vial.
out unsealed vial with BA and let dry
10g test cyp powder to unsealed vial
12mls (NOT %) benzyl benzoate to powder
3mls benzyl alcohol
glass rod to stir solution, while the powder starts to dissolve.
a pot of water on stove, and bring to a boil
cottonseed Or GSO ,until it is about 3-4 ccs (estimate) shy of the marker line.
rubber stopper on unsealed vial, and put a 25g needle through it.
vial in boiling water until the solution is no longer cloudy.
off sterile vial stopper with alcohol wipe, and put 25 g needle through it.
filters, and 10cc sryinges, start to filter the solution into the sterile vial.
all the solution is in the vial, filter more cottenseed oil though the SAME Filter, up to the marker line on vial. reason for this is to push through any 1-test cyp left in the filter.
solution, with 25g needle in stopper, at 250 degrees for 45 minutes.
Stacking is taking multiple types of steroids at once or mixing oral and injectable formulations. Many steroid abusers believe stacking increases results, but this method has not been scientifically proven.